http://www.amazon.com/Selens-Umbrella-Bracket-Yongnuo-SE-31/dp/B00URCNY8...
I have Selens Flash Shoe Umbrella Holder Light Stand Bracket for Canon/ Nikon/ Yongnuo (SE-31), Yongnuo YN622N-TX controller and Yongnuo YN622N transceiver alongwith Yongnuo YN568EX.
I tried mounting 2 flash and 1 transceiver on this mount. Used Yongnuo LS-PC635 to connect transceiver with the mount using 3.5mm Sync jack on tranceiver. But its not triggering the flashes. I have no clue where i am going wrong. This sync cable is helping me triggering my studio strobe lights so i feel wire is not detective. I am not sure if i am doing it all right or mout itself is defective.
Please help me with this.
Is there any other way to trigger these specific speedlites using 1 transceiver.
Thnx in advance
There's a few things that could be causing the issue. First, make sure that your controller and transceiver are both on the same channel. Assuming that they are, the next thing I would suggest is that whatever speed light you connect the PC Sync cable to, make sure that speed light is set to manual mode, and not TTL. Try that out and if it fires, you're good to go. If you want multiple speed lights to fire only using one transceiver, then the other speed lights that are not connected via PC sync cord, must be set to slave mode.